Product Description

Includes multi-angled trap for easy installations. Although branded ISE, it is suitable for all brands of waste disposers.

** If in doubt to whether you need one, we always suggest to think about the cost of your plumber leaving the job to buy one or you having to re-arrange a second visit **

N.B. This plumbing kit can only be ordered with a waste disposer at the same time.

EAN - 050375002628

Product Description

Replacement Push Button & Bellows Kit - 64452

Suitable for 45, 55, 65, 75 Models with an Air Switch except Evolution Models

33mm Diameter Cut-out size
45mm Diameter of button

Includes;
- 2 x Interchangeable POLISHED CHROME and WHITE finish buttons.
- 2 metres of PVC air tube

To install the push button bellows;

Remove the nut on the existing push button (this replacement is not supplied with the nut).

Push one end of the PVC tubing onto the spout of the push button bellows, feed the other end of the tube through the hole in worktop and through the nut underneath the worktop.

Fit the push button bellows into the hold and then screw up the nut underneath the worktop until it is hand tight. Do not use a spanner to tighten the nut.

Then simply take the other end of the air tube and push it over the spout of the air switch, which is located on the underside of the waste disposer (or into the transformer if using the ISE Air Switch separate unit).

POSTAGE ONLY £1.95

Product Description

Replacement Push Button & Bellows Kit - 75430

Suitable for Evolution E100 and E200 Models

33mm Diameter Cut-out size
45mm Diameter of button

Includes;
- 2 x Interchangeable POLISHED CHROME and BRUSHED STEEL finish buttons.
- 2 metres of PVC air tube

To install the push button bellows;

Remove the nut on the existing push button (this replacement is not supplied with the nut).

Push one end of the PVC tubing onto the spout of the push button bellows, feed the other end of the tube through the hole in worktop and through the nut underneath the worktop.

Fit the push button bellows into the hold and then screw up the nut underneath the worktop until it is hand tight. Do not use a spanner to tighten the nut.

Then simply take the other end of the air tube and push it over the spout of the air switch, which is located on the underside of the waste disposer (or into the transformer if using the ISE Air Switch separate unit).

POSTAGE ONLY £1.95

Product Description

Suitable for continuous feed models ISE 45 & 55.

The button can be located on the worktop & is supplied with interchangeable brushed steel & chrome finishes. Pressing the button sends a pulse of air through the tube to the disposer to switch it on and off.

** ISE Models 45A/S, 65, E100 & E200 are already supplied with an in-built air switch.**

33mm Diameter Cut-out size
45mm Diameter of button

EAN Barcode - 094922158215

Product Description

Enables food waste disposers to be fitted in sinks above 20mm and up to 35mm thickness (except Belfast sink with integral overflow).


N.B. Chrome plug pictured not included.

Product Description

Converts the ISE Evolution 100 or 200 into a Batch Feed.

  The Batch Feed Control cannot be used with a CERAMIC sink

EAN - 094922158154